Table of Contents
Advertisement
Operational Instructions
Hands Free Speakerphone
- Outgoing calls
To place a call, simply initiate the call from your compatible Bluetooth
phone and the call will automatically be routed through your paired
LoudSpeak'r.
- Incoming calls
• Press
to answer the call on your speaker.
• Press and hold
to reject the call.
- During a call
• Press
to hang up.
• Press and hold
to route the call back and forth between your phone
and the speaker.
• Double press
to answer call waiting.
• Double press
to toggle between the original call and the new call.
• Press
or
at anytime during the call to mute your microphone. The
light indicator will blink blue.
LED Light Indicator (on front of speaker)
- No light: Power OFF
- Flashing blue & red: Paring Mode
- Solid blue: Power ON (Battery level>30%)
- Solid red: Power ON (Battery level<30%)
- Blinking red/Auto power OFF in 5 mins: Power ON (Battery level<10%)
- Flashing blue: Charging
- No light: Power OFF + fully charged
Page 10
Troubleshooting
Symptom
Solution
Music is not
Make sure your Bluetooth device has A2DP
streaming over
profile.
Bluetooth
Check if both devices are paired and connected
over Bluetooth.
Restart the LoudSpeak'r to auto-connect with
your Bluetooth device.
No power
Make sure LoudSpeak'r is fully charged.
LoudSpeak'r
Make sure your mobile device has HSP/HFP
doesn't answer
profile.
phone calls
Check if both devices are paired and connected
over Bluetooth.
Restart the LoudSpeak'r to auto-connect with
your Bluetooth device.
Music doesn't
Press play to resume music.
resume after
hanging up a call
No music control by
Make sure your Bluetooth device has AVRCP
LoudSpeak'r
profile.
Remarks:
If troubleshooting does not eliminate the problem, shut down the speaker by
sliding the switch on the back to OFF . In case the problem still exists, see
warranty information on page 13 and page 14 to obtain service.
Page 11
Advertisement
Table of Contents
