Pedestal Installation - LG WM2455H User's Manual & Installation Instructions

O P T I O N A L AC C E S S O R I E S
PEDESTAL ACCESSORY
The pedestal accessory includes:
• Pedestal base • Eight (8) screws
• One (1) drawer divider • Wrench
• Four (4) brackets
Tools Needed for Installation:
• Phillips-head screwdriver
• Wrench (supplied)

PEDESTAL INSTALLATION

For dryer
For washer/combo
Make sure the leveling feet of the appliance
1
are fully retracted (see detail for leveling
washer feet in Step 2); then position the
appliance on top of the pedestal.
The washer feet will fit into the outermost
corner positions and the dryer feet will fit into
the innermost positions as shown.
NOTE: The appliance and pedestal assembly
must be placed on a solid, sturdy, level floor
for proper operation.

MFL31245113_ENG.indd 34-35
To ensure safe and secure installation, please
thoroughly follow the instructions below.
wWARNING
• Incorrect installation can cause serious
accidents.
• The appliances are heavy. Two or more
people are required when installing the
pedestal. There is a risk of serious back injury
or other injuries.
• Do not allow children to play in or on the
drawer. There is a risk of suffocation or injury.
• Do not step on the handle. There is a risk of
serious injury.
• If appliances are already installed,
disconnect them from all power, water, or
gas lines and from draining or venting
connections. Failure to do so can result in
electrical shock, fire, explosion, or death.
Tighten all 4
locknuts securely
Once the leveling feet of the washer are fully
2
retracted, tighten all locknuts securely.
NOTE: The leveling feet on the dryer do not
have locknuts.
O P T I O N A L AC C E S S O R I E S
PEDESTAL INSTALLATION
(cont.)
Make sure the side surface of the appliance
3
is clean and dry. Remove paper backing from
the tape on the bracket.
Install 2 screws to securely attach the bracket
5
to the pedestal.
Once properly attached, firmly press the top
part of the bracket with the double-sided
tape to the side of the appliance. Repeat
steps 2–4 to attach the other brackets.
NOTE: If the brackets are not installed
properly, noise and vibration may result. Be
sure to remove paper backing and to use all
screws to install the brackets.
Move the appliance to the desired location.
Position the bracket as shown. The bent part
4
of the bracket should rest along the edge
of the pedestal, and the holes in the bottom
part of the bracket should align with the
holes in the pedestal.
Raise Lower
Loosen the locknuts on all 4 leveling feet
6
of the pedestal until you can turn them
with the wrench. Turn clockwise to raise
or counterclockwise to lower. Once the
pedestal is level and all 4 feet are solidly
against the floor, securely tighten all locknuts
by hand.
NOTE: Noise and vibration may result if
locknuts are not tightened.
Be sure to connect the appliances to all
water, power, or gas lines and draining or
venting connections before operation.
If there is excessive vibration during the
first operation after installation, slightly
adjust the leveling feet.

2007.10.4 2:32:11 PM