Spray Gun Operation - AIRLESSCO Spray & Stripe 3600 Service And Operation Manual

Spray Gun Operation

SPRAY GUN
Attach spray gun to airless unit and tighten fittings securely.
Set the gun safety latch. (Also may be called gun safety
lock, or trigger lock)
* The gun safety latch should always be set when the gun is
not being triggered.
Read all warnings and safety precautions supplied with the
spray gun and in product manual.
MAJOR COMPONENTS OF SPRAY GUN &
REVERSIBLE REV-TIP
Reversible
Spray Tip
Tip Guard
Trigger Guard
Press up here & pull gently
to remove trigger guard
SPRAY TIP ASSEMBLY
1. Be sure the pressure relief procedure is followed
before assembling tip and housing to the gun.
2. Insert REV-TIP™ cylinder into the REV-GUARD
(guard housing assembly).
3. Guide the metal seat into REV-GUARD™ (guard
housing assembly) through the retaining nut & turn
until it seats against the cylinder.
4. Insert the O-Ring gasket onto the metal seat so that it
fits into the grooves.
5. Finger tighten REV-GUARD™ retaining nut onto the gun.
6. Turn guard in the desired position.
7. Completely tighten the retaining nut.
REV-GUARD™
Guard Housing Assembly
G Thread 7/8" 561-002
F Thread 11/16" 561-001
CLEANING SPRAY GUN
Immediately after the work is finished, flush the gun out
with a solvent. Brush pins with solvent and oil them
lightly so they will not collect dried paint.
14
™
Retaining Nut
Metal Seat
Part # 561-029
REV-TIP™ Cylinder
Part # 561-XXX
Gun Safety
Latch or Lock
Gun Handle. Unscrew
from gun head to service
filter inside.
TO REMOVE CLOGS FROM SPRAY TIP
1. Lock gun safety latch.
2. Turn REV-TIP™ handle 180 degrees.
3. Disengage trigger lock and trigger gun into
the pail.
4. If the REV-TIP™ handle appears locked
(resists turning), loosen the retaining nut. The
handle will now turn easily.
5. Engage gun safety latch and return handle to
the spray position.
O-Ring Gasket
Part # 561-026
CLEANING FILTER IN GUN HANDLE
To clean the filter, use a brush dipped in an
appropriate solvent. Change or clean filters
at least once a day. Some types of latex may
require a filter change after four hours of
operation
Retaining Nut
Reverse to
Unplug
Spray Position Shown
.
™