Precise Adjustment(Azimuth Adjustment); X-Value Adjustment - LG TL-AT130M Service Manual

DECK MECHANISM ADJUSTMENT
5-2. Confirm that the tape passes smoothly
between the Take-up Guide and Pinch
Roller(using a mirror or the naked eye).
1) After completing Step 5-1.(Preliminary Adjustment), check
that the tape passes around the Take-up Guide and Pinch
Roller without folding or curling at the top or bottom.
(1) If folding or curling is observed at the bottom of the
Take-up Guide then slowly turn the Tilt Adjustment
Screw(C) in the clockwise direction.
5-3. Precise Adjustment (Azimuth adjustment)
Test Equipment/ Fixture
• Oscilloscope
• Alignment Tape(SP)
• Screw Driver(+) Type 5mm
Adjustment Procedure
1) Connect the probe of the oscilloscope to Audio Output
Jack.
2) Alternately adjust the Azimuth Adjustment Screw(A) and
the Tilt Adjustment Screw(C) for maximum output of the
1KHz and 7KHz segments, while maintaining the flattest
envelope differential between the two frequencies.

6. X-Value Adjustment

Purpose: To obtain compatibility with the other VCR(VCP) Models.
Test Equipment/ Fixture
• Oscilloscope
• Alignment Tape(SP only)
• Screw Driver(+) Type 5mm
Adjustment Procedure
1) Release the Automatic Tracking to run long enough for
tracking to complete it's cycle.
2) Loosen the Fixed Mounting Screw and move the Base
Assembly A/C Head in the direction as shown in the dia-
gram to find the center of the peak that allows for the max-
imum waveform envelope.
This method should allow the 31µm Head to be centrally
located over the 58µm tape track.
3) Tighten the Base Assembly A/C Head mounting Screw.
Connection Point
• Audio output jack
Connection Point
• CH-1: PB RF Envelope
• CH-2: NTSC: SW 30Hz
PAL: SW 25Hz
• Head Switching Output
Test Point
• RF Envelope Output Test
Point
(2) If folding or curling is observed at the top of it then
slowly turn the Tilt Adjustment Screw(C) in the
counterclockwise direction.
NOTE:
Check the RF envelope after adjusting the A/C Head, if the
RF waveform differs from Fig. C-5-4, performs Precise
Adjustment to flat the RF waveform.
Test Conditions
(Mechanism Condition)
• Play an Alignment Tape
1KHz, 7KHz Sections
1KHZ
A:Maximum
Test Conditions
(Mechanism Condition)
• Play an Alignment Tape
Adjustment Diagram
X-Value Adjustment Hole
Fixed Screw
Azimuth Adjustment
Screw(A)
Connection Diagram
RF ENVELOPE OUTPUT TEST POINT
HEAD SWITCHING OUTPUT TEST POINT
4-17
Adjustment Point
• Azimuth Adjustment Screw(A)
• Height Adjustment Screw(B)
B:Maximum
Fig. C-5-4
Adjustment Point
Groove at the
Base A/C
Left
Right
Tilt Adjustment Screw(C)
Height Adjustment Screw(B)
OSCILLOSCOPE
CH-1 CH-2
7KHZ