Operating Instructions - Comfort Glow EF5675R Owner's Manual

A
MAIN POWER (A): Push button "A" to turn electric fireplace on. (Ensure that the red power light "B" above
the main power button is on – this confirms that the unit is plugged in. It will turn to green when the main
power button is pushed.
 The flame effect will automatically come on when the electric fireplace is on
FAN BUTTON (C): This is a High and Low setting for the fan and the heater. Note that the fan will only come
on if the thermostat temperature id set above the room temperature. The fan light "D" denotes the Low fan
setting and the fan light "E" denotes the High setting.
TIMER (F): If a timer is desired, push button "F" once for a 1 hour timer twice for a 2 hour time, etc (up to 12
hours). The time will show on the digital readout screen. To reset, keep pushing the timer button "F" until it
returns to your desired time setting.
 Note: that the timer is approximate and extreme caution is necessary when the electric fireplace is left
operating and unattended. Keep children, invalids and pets away from the unit when in use.
TEPMERATURE INCREACE (G) DECREASE (H): This electric fireplace is equipped with a thermostat.
Press the Temperature button "G" to increase the temperature. Press the Temperature button "H" to
decrease the temperature. The electric fireplace heater and fan will only turn on if the temperature setting is
higher than the room temperature.
THE TEMPERATURE DIGITAL READOUT SCREEN (I): This screen shows the current setting of the thermostat in
Celsius or Fahrenheit degrees. Use the "L" Button to adjust the setting to °C or °F.
Press the "L" button on the control panel for 3 seconds and after a short "beep" sound the display screen will
show the real room temperature for 5 seconds. It will then change back to the set temperature. The screen
will turn off after 5 minutes if there are no temperature adjustments. The temperature light "J" indicates
Fahrenheit. The temperature light "K" indicates Celsius.
 Note: The fan will continue to work for several minutes when the heater turns off. This allows the
infrared components inside the heater to cool down

OPERATING INSTRUCTIONS

B D E
D
D
C
I K J
F G H
~ 6 ~
L