Table of Contents
Advertisement
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
Chassis
Figure 25 - Installing One-Piece Log Set
107188
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
Place one-piece log set on grate to fit as
illustrated in Figure 25. Make sure back
section of log set is seated into "U"-shaped
cutout in center of chassis (see Figure 25).
IMPORTANT: Make sure log does not cover
any burner ports (see Figure 26).
One Piece Log Set
Burner Ports
Figure 26 - Installing One-Piece Log set
(Top View)
One Piece Log Set
Burner
"U"-shaped
Cutout in
Chassis
15
OWNER'S MANUAL
OPERATING
FIREPLACE
FOR YOUR SAFETY
READ BEFORE
WARNING: If you do not fol-
low these instructions exactly, a
fire or explosion may result caus-
ing property damage, personal
injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all
around the appliance area for gas. Be
sure to smell next to the floor because
some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL
GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas sup-
plier, call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn
by hand, don't try to repair it, call a
qualified service technician or gas
supplier. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to in-
spect the appliance and to replace any
part of the control system and any gas
control which has been under water.
Ignitor Button
Figure 27 - Control Knob and Ignitor
Button
For more information, visit www.desatech.com
LIGHTING
Control Knob
Continued
Advertisement
Table of Contents
