Table of Contents
Advertisement
VENT-FREE NATURAL GAS BAY FRONT FIREPLACE
INSTALLATION
Continued
Installing 9-Volt Battery (Not
Included) in Hand-Held Remote
Control Unit
1.
Remove battery cover on back of re-
mote control unit.
2.
Attach terminal wires to the battery.
Place battery into the battery housing.
3.
Replace battery cover onto remote con-
trol unit.
Battery
Cover
Terminal
Wires
9-Volt
Battery
Figure 31 - Installing Battery in Hand-
Held Remote Control Unit
CF26NR
OPERATING
FIREPLACE
FOR YOUR SAFETY
WARNING: If you do not fol-
low these instructions exactly, a
fire or explosion may result caus-
ing property damage, personal
injury or loss of life.
Remote
A. This appliance has a pilot which must
Control Unit
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all
around the appliance area for gas. Be
sure to smell next to the floor because
some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL
Battery
GAS
Housing
• Do not try to light any appliance.
• Do not touch any electric switch;
do not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas sup-
plier, call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn
by hand, don't try to repair it, call a
qualified service technician or gas
supplier. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part
of the control system and any gas con-
trol which has been under water.
Ignitor Button
Figure 32 - Control Knob and Ignitor Button Location (Shown as Supplied,
No Control Options)
READ BEFORE
LIGHTING
Flame Adjustment Knob
AUTO
OFF
ON
Selector Switch
16
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation
of new heater, burning logs will
give off a paper-burning smell.
Open awindow to vent smell. This
will only last a few hours.
1.
STOP! Read the safety information,
column 2.
2.
Make sure manual shutoff valve is
fully open.
3.
Set switch to OFF position.
WARNING: Burners will come
on automatically within one minute
when the selector switch is in the
ON position after the pilot is lit.
4.
Press in and turn control knob clock-
wise
to the OFF position.
5.
Wait five (5) minutes to clear out any
gas. Then smell for gas, including
near the floor. If you smell gas,
STOP! Follow "B" in the safety in-
formation. If you don't smell gas, go
to the next step.
6.
Press in and turn control knob coun-
terclockwise
position. Press in control knob for
five (5) seconds (see Figure 32).
Note: You may be running this
heater for the first time after hook-
ing up to gas supply. If so, the con-
trol knob may need to be pressed in
for 30 seconds or more. This will al-
low air to bleed from the gas system.
7.
With control knob pressed in, press
and release ignitor button. This will
light pilot. The pilot is attached to the
front burner. If needed, keep press-
ing ignitor button until pilot lights.
Control Knob
to the PILOT
105443
Advertisement
Table of Contents
