Table of Contents
Advertisement
3
Press the left- or right-arrow button to
select a digit to change.
4
Press the up- or down-arrow button, or
turn the MENU knob to change the
digit.
5
3
Repeat steps
and
6
Press the SET/S.SEL button or the
MENU knob.
"OK" is selected.
7
Press the SET/S.SEL button or the
MENU knob.
To clear planning metadata
See page 109 for more information about GUI
screen operations.
1
Display the Disc Menu.
2
Select "Clear Planning Metadata", and
then press the SET/S.SEL button or the
MENU knob.
A message appears asking you to confirm
that you want to clear the planning metadata.
3
Select "OK", and then press the SET/
S.SEL button or the MENU knob.
The planning metadata is cleared from this
unit's memory.
To switch the title display in the LCD
monitor and viewfinder
When planning metadata is loaded into this unit,
you can select the format of the title to display in
the LCD monitor and viewfinder.
See page 109 for more information about GUI
screen operations.
1
Display the Disc Menu.
4
as required.
2
Select "Settings", and then press the
SET/S.SEL button or the MENU knob.
3
Select "Planning Clip Name in Clip
Info. Area", and then press the SET/
S.SEL button or the MENU knob.
See page 29 for more information about the
Clip Info. Area.
4
Select one of the following, and then
press the SET/S.SEL button or the
MENU knob.
ASCII Clip Name: Display the ASCII
format title (see page 93).
Clip Name: Display the UTF-8 format title
(see page 93).
To display clip names in the clip
information area in the viewfinder
1
Display the Disc Menu.
2
Select "Settings", and then press the
SET/S.SEL button or the MENU knob.
3
Select "Planning Clip Name Display"
(whether to display the clip name in the
viewfinder screen), and then press the
SET/S.SEL button or the MENU knob.
4
Select "Enable", and then press the
SET/S.SEL button or the MENU knob.
Clip information is always shown in the warning
indicator area of the LCD monitor if the LCD
monitor is set to status display.
Checking user-defined essence
marks
You can display the names of user-defined Shot
Mark0 to Shot Mark9 essence marks in planning
metadata (UTF-8 format, maximum 32 bytes).
1
Display the Planning Metadata
Properties screen (see page 130) for the
planning metadata loaded into this unit.
The , button is enabled when the planning
metadata contains user-defined essence
marks (see page 94).
Disc Operations
131
Advertisement
Table of Contents
