Table of Contents
Advertisement
Programming
the Remote
Programming
the
G
The remote control is a multi-brand
or universal remote control. It can be programmed
to operate most remote-controllable
devices of other manufacturers.
Note that the remote control may not control all models of other brands.
1. Test your remote control.
To find out whether your remote control can operate the component
without programming,
turn on the component
such as a VCR
and press the corresponding
MODE button (VCR) on the remote control, while pointing at the component.
Test the POWER and
CH +/- buttons to see if the component
responds properly. If not, the remote requires programming
to operate the device.
2. Turn on the component
to be programmed,
then press the corresponding
MODE button on the remote control.
3. Press the PIP CH- and MUTE buttons simultaneously,
the remote control is ready to be programmed for the code.
4. There are two ways to find the right code for the component.
A. If you press the CH +/- buttons repeatedly, the codes will change one at-a-time.
Press the POWER button after each code
change. If the right code is found, the device will turn off.
B. Enter a code number using the number buttons on the remote. Programming
code numbers for the corresponding
component
can be found on the following pages. Again, if the code is correct, the device will turn off.
5. Press the MENU button to store the code.
6. Test the remote control functions to see if the component
responds properly. If not, repeat from step 2.
44
Plasma TV
Advertisement
Table of Contents
