Table of Contents
Advertisement
28
WIRELESS PROGRAMMING (OPTIONAL ACCESSORY)
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one
should enter or leave garage while door is in motion. Do not allow children to operate push button(s)
or transmitter(s). Do not allow children to play near the door.
The transmitters supplied with your opener are pre-pro-
grammed to your receiver in the factory. If you purchase
additional transmitters, you will need to program them into
your opener using the steps below.
Program the Receiver to Match Additional Transmitter
Codes:
Using the "LEARN" Button
1. Press and hold the button on the hand-held transmitter
or wireless door button that you wish to operate your
garage door (1).
2. The orange led will flash continually. Press and release
the "learn" button on the opener (2). The learn indicator
led will go out.
3. Release the transmitter or wireless door button when the
opener light blinks. It has learned the code. If light bulb
is not installed, two clicks will be heard (3).
Using the Motion Detecting Control Panel (optional
accessory):
1. Press and hold the button on the hand-held transmitter
that you wish to operate your garage door (1).
2. While holding the transmitter button, press and hold the
LIGHT button on the Motion Detecting Control Panel (2).
3. Continue holding both buttons while you press the push
bar on the Motion Detecting Control Panel (all three
buttons are held) (3).
4. Release buttons when the opener light blinks. It has
learned the code. If the light bulb is not installed, two
clicks will be heard (4).
To Erase all Transmitter Control Codes
To deactivate any unwanted transmitter(s), first erase all
codes:
Press and hold the "learn" button on the opener until the
learn indicator light goes out (approximately 6 seconds).
All previous codes are now erased. Re-program each
transmitter or keyless entry you wish to use.
PROGRAMMING C379 WIRELESS
FINGERPRINT ACCESS SYSTEM
(optional accessory)
Full instruction are available with this accessory.
Once you have enrolled your user into the C379 you can
program the unit into your opener.
Using the orange "LEARN" Button:
1. Press and release the orange "learn" button on opener.
The learn indicator light will glow steadily for 30 sec-
onds.
2. Within 30 seconds, slide the cover of the C379 up as
illustrated (A). Swipe your finger on the reader head at a
steady speed (B) until the yellow led turns on (C).
3. When the opener light blinks (3). It has learned the
code. If the light bulb is not installed, two clicks will be
heard, ensure there are no obstructions in the path of
the door, then press the Send button (D) to test the door.
1
1
2
17
2
3
3
4
Hide quick links:
Advertisement
Table of Contents
