Vcr Setup - LG DU-50PY10 Owner's Manual

Installation
3. Analog and Digital TV signals provided on cable and antenna
Cable TV Wall
Jack
Note: The TV will let you know when the analog, cable, and digital channel scans are complete.

VCR Setup

VCR Setup
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV
- Use the ISM Method (on the Option menu) feature to avoid having a fixed image remain on the screen for a long period of time.
If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.
Connection Option 1
Set VCR output switch to 3 or 4 and then tune
TV to the same channel number.
Connection Option 2
1. Connect the audio and video cables from the
VCR's output jacks to the TV input jacks, as
shown in the figure.
When connecting the TV to VCR, match the
jack colors (Video = yellow, Audio Left = white,
and Audio Right = red).
If you connect an S-VIDEO output from VCR to
the S-VIDEO input, the picture quality is
improved; compared to connecting a regular
VCR to the Video input.
2. Insert a video tape into the VCR and press
PLAY on the VCR. (Refer to the VCR owner's
manual.)
3. Select the input source with using the
TV/VIDEO button on the remote control. (If
connected to A/V INPUT , select Video input
source)
Do not connect to both Video and
S-Video at the same time.
14 Plasma TV
Antenna
RF Coaxial Wire (75 ohm)
Analog Antenna
RF Coaxial Wire (75 ohm)
Signal
Amplifier
Bronze Wire
Turn clockwise to tighten.
• In a poor signal area to improve picture quality, purchase
and install a signal amplifier.
• If the antenna needs to be split for two TV's, install a "2-
Way Signal Splitter" in the connections.
• If the antenna is not installed properly, contact your deal-
er for assistance.
HDMI / DIGITAL AUDIO(OPTICAL)
DVI(VIDEO)
COMPONENT2
DVI
AUDIO INPUT
VIDEO INPUT
1
ANT OUT
S-VIDEO
ANT IN OUT
(R) AUDIO (L)
OUTPUT
SWITCH
3 4
IN
Cable
ANTENNA CABLE
AC INPUT
Cable
CABLE
ANTENNA
2
VCR Rear
VIDEO
AC INPUT AC INPUT