Ignition Switch - Supra Sunsport 20V Owner's Manual

Ignition Switch

Located on the port side of the dashboard, the ignition switch
has four positions. In the vertical position the ignition is "OFF".
In the OFF position, only the blower and bilge switches are
powered.
One position counterclockwise is the "ACC" position. This will
power the dash switches.
One position clockwise is the "ON" position and this will power
the switches and energize the motor.
The full clockwise position is the "START" position.
NOTE: All electrical equipment should be turned off when
the boat is in storage.
Horn Button
The Horn Switch is located on the port dash panel near the
ignition. Sound the horn by depressing the button.
— 44
Blower Switch
The blower switch activates the blower motor. The primary
function of the blower fan is to remove any fumes from the
bilge area. The blower also draws fresh air into the engine
compartment.
Never depend solely on the blower to eliminate dangerous
fumes. Before starting the engine, always open the motor box to
check if fumes are present. Switch on the blower fan a minimum
of four minutes before starting the engine.
NOTICE: If the blower fails to operate, reset the circuit
breaker. If the blower still does not operate, notify your
Supra dealer.
Failure to operate the blower in accordance with the Coast
Guard Recommendation could result in an explosion.
Horn/Whistle Signals
One Long Blast:
Warning Signal (Coming out of slip)
One Short Blast:
Pass on my Port Side
Two Short Blasts:
Pass on my Starboard Side
Three Short Blasts:
Engines in Reverse
Four or More Blasts:
Danger Signal
1. OVERTAKING / PASSING: Boat being passed has the right-of-
way. KEEP CLEAR.
2. MEETING HEAD-ON: Keep to the right.
3. CROSSING: Boat on the right has the right-of-way. slow down
and permit him to pass.
© 2010 Skier's Choice, Inc.