Trailer Alignment - Supra Sunsport 20V Owner's Manual

Connecting the Trailer
When connecting the trailer to your tow vehicle, use the
following procedure:
1. Raise the tongue with the trailer jack. Position the trailer
tongue directly over the 2" ball, and lower the jack until the
tongue goes all the way down over the ball.
2. Press down on the latch until it locks on the ball with a
"click. "
NOTICE: If your hitch ball has an excessive flat spot on
top, the latch may not engage properly. If the latch does
not catch, check with your dealer or hitch installer before
trailering.
3. Insert the locking pin into the tongue. Lock pin hole is on
the side of the tongue.
4. When all weight is off the trailer jack, pull the jack lock pin
and rotate the jack to the horizontal position and re-lock
the pin.
5. Attach the safety cables to the tow vehicle hitch. Cross the
cables and wrap them around each other once or possibly
twice allowing just enough slack to permit tight turns of the
vehicle and trailer.
6. Plug the trailer lights connector to the vehicle harness.
7. Clip the brake lockout cable to the vehicle hitch.
— 80

Trailer Alignment

Correct Alignment
When pulling the boat onto the trailer, be sure that it is centered
on the trailer.
Incorrect Alignment
The distance between the boat and the wheel runner board
should be equal on both sides.
© 2010 Skier's Choice, Inc.