Panel Explanation - Draytek Vigor2830N Quick Start Manual

1 . 1 P a n e l E x
1 . 1 P a n e l E x
LED Status
ACT Blinking
(Activity)
Off
USB On
Blinking
CSM On
WLAN On
Blinking
DSL On
Blinking
WAN2 On
Blinking
DoS On
Blinking
VPN On
On
QoS
LED on Connector
Left LED
GigaLAN
(Green)
1/2/3/4
Right LED
(Green)
Vigor2830n V2 Quick Start Guide
p l a n a t i o n
p l a n a t i o n
Explanation
The router is powered on and running normally.
The router is powered off.
USB device is connected and ready for use.
The data is transmitting.
The profile(s) of CSM (Content Security
Management) for IM/P2P, URL/Web Content
Filter application can be enabled from Firewall
>>General Setup. (Such profile must be
established under CSM menu).
Wireless access point is ready.
It will blink slowly while wireless traffic goes
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will
return to normal condition after two minutes.
(You need to setup WPS within 2 minutes.)
The router is ready to access Internet through
DSL link.
Slowly: The DSL connection is ready.
Quickly: The connection is training.
The WAN2 connection is ready.
It will blink while transmitting data.
The DoS/DDoS function is active.
It will blink while detecting an attack.
The VPN tunnel is active.
The QoS function is active.
On
Off
Blinking
On
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with
1000Mbps.
2