Mackie Digital 8-Bus Service Manual page 3

! SMD !
The d8b makes extensive use of
surface mount components.
Servicing technicians should have the
tools, experience and patience to perform
surface mount rework.
Additional Safety Information
Mackie Designs' Digital 8•Bus has been tested and conforms to the following standards
and directives of the European Council:
73/23/EEC
89/336/EEC
IEC 950(1991)/EN60950:1992 Electrical Safety Requirements
EN55103-1 and EN55103-2
Note: The following notice concerns the lithium battery located on the motherboard
inside the Remote CPU.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER. DISPOSE OF
USED BATTERIES ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS.
ATTENTION: IL Y A DANGER D'EXPLOSION S'IL Y A REMPLACEMENT INCORRECT DE LA
BATTERIE, REMPLACER UNIQUEMENT AVEC UNE BATTERIE DU MEME TYPE OU D'UN TYPE
ÉQUIVALENT RECOMMANDÉ PAR LE CONSTRUCTEUR. METTRE AU REBUT LES BATTERIES USAGÉES
CONFORMÉMENT AUX INSTRUCTIONS DU FABRICANT.
WARNING
Service on the d8b must only be
undertaken by experienced service
technicians.
Low Voltage Directive with amendments
91/263/EEC, 89/392/EEC, and 89/336/EEC
EMC Directive
Residential (E1) and Commercial (E2) Environments
! ESD !
The d8b contains components that
may be damaged by elecrostatic
discharge. All standard ESD
precautions must be taken when
servicing.
3