Mackie Digital 8-Bus Service Manual page 19

DCA connectors
J9
Analog signals
going out to
Analog I/O
This is a compilation of all the DCA
board's connectors, mainly showing
the analog inputs, data received and
transmitted.
The DCA board receives the analog
J11
Buses, Auxes, Mixes and Solos from the
Analog signals
DSP board, then outputs (under
coming in from control by the Brain board) to the
CODEC board Analog I/O board and Bus out.
J10
NOTE: The DB25 connector has
Analog signals
going out to
different pin numbering. See
Analog I/O
Connectors chapter, page C-7.
Also see previous page, about
bus renumbering.
J11 J10 J9
J8
DCA 112
J8
Analog signals,
going to rear panel
8 BUS OUT
J60
J31
J31
To Brain
19
DSP SIGNAL FLOW