Arming Commands; Quick Arming - Honeywell VISTA-20PSeries User Manual

Arming the System

Arming Commands

Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.
Mode Press these keys...
security code +
STAY
security code +
NIGHT-
STAY
security code +
INSTANT
security code +
AWAY
MAXIMUM security code +

Quick Arming

If "Quick Arming" was programmed by the installer, the
place of the security code when arming the system in any of the arming modes.
However, the 4-digit security code must always be used to disarm the
system.
Function Key Arming
For any arming command, a function key may have also been programmed for your
system. If so, you can press and hold the appropriate function key for 2 seconds to
arm the system. See your installer for the designated functions (see Single Button
Arming section).
Refer to the Accessing Other Partitions section for information on multi-partition
arming (VISTA-20P/PS Series only).
– 18 –
(cont'd)
Keypad Confirms By...
• three beeps
3
STAY
• armed STAY message displayed
• red ARMED indicator lights
• three beeps
3 + 3
STAY STAY
• NIGHT-STAY message displayed
• red ARMED indicator lights
• three beeps
7
INSTANT
• armed STAY message displayed
• red ARMED indicator lights
Note that entry delay is turned off.
two beeps, or, if programmed, beeping for
2
AWAY
duration of exit delay
• armed AWAY message displayed
• red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The keypad beeps
rapidly during the last 5 seconds of the
exit delay to warn you that it is ending.
• same as AWAY (described above)
4
MAX
Note that entry delay is turned off.
key can be pressed in
[#]