Safety Cut-Out; Care And Cleaning - Flavel Inspire FWR**0R Series Installation And User Instruction Manual

IMPORTANT : Safety Cut Out
This appliance is fitted with an automatic safety cut out. This operates if
the air outlet at the top of the product becomes covered or blocked. This
will prevent the fan heater from operating.
In order to RESET the appliance the following procedure should be
followed:-
Switch OFF the appliance and disconnect the appliance from the mains
supply
Leave the appliance disconnected for a MINIMUM of 10mins
Check the appliance is free from all obstructions and remove safely
Switch ON the appliance at the mains supply socket
Operate the appliance as shown on the previous page
If the appliance fails to operate, repeat the above procedure ENSURING
the appliance is disconnected from the mains supply at the wall socket.
If after repeating this procedure the appliance fails to operate CHECK the
fuse within the wall socket / plug. If after carrying out both of the above
procedures the appliance still fails to operate, then call a suitably qualified
person or CFM Europe Ltd. Service Centre on the number shown on the
rear cover of this booklet.

Care and Cleaning

Always disconnect the appliance from mains supply and allow to cool
before any cleaning operation begins.
Metal painted parts may be cleaned using a clean, damp cloth.
Never use any abrasive cleaners and chemical agents as damage may
occur to the paint finish.
7