Advertisement

Quick Links

INSTALLATION AND USER INSTRUCTION GUIDE
Inspire
Model No (s)
FWR**0R*
FWR**ER*
** Denotes fuel effect type and trim colour
* Denotes trim type
0 Denotes UK model
E denotes European model
Electric Heater
This guide should be used to install and care for your
Flavel Electric heater.
Read all information carefully prior to
installation and use.

Advertisement

Table of Contents
loading

Summary of Contents for Flavel Inspire FWR**0R Series

  • Page 1 ** Denotes fuel effect type and trim colour * Denotes trim type 0 Denotes UK model E denotes European model Electric Heater This guide should be used to install and care for your Flavel Electric heater. Read all information carefully prior to installation and use.
  • Page 2 Installation IMPORTANT Please read the instructions below before installation or use of this Flavel Electric Heater. NEVER use this heater where it may come into contact with water i.e. bathroom, shower room, kitchen. NEVER leave unsupervised children where the heater is left switched ON or is left unguarded.
  • Page 3: Appliance Data

    Staffordshire ST4 4TJ Installation Requirements The Flavel Electric heater is supplied with a moulded three-pin plug (13 Amp) and approximately 1.8 metres of flexible mains cable (1mm 2 ). The appliance and surround should therefore be located close to a suitable mains socket to enable connection.
  • Page 4 Before use ensure that the supply voltage matches that marked on the appliance. The mains cable should be routed from the heater to the socket connection without being trapped or being liable to damage. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazard.
  • Page 5: Unpacking The Appliance

    Unpacking The Appliance The Flavel Electric heater is supplied in a single pack carton. All Instructions should be read prior to unpacking or installing the appliance. Ensure all parts including loose items have been removed prior to discarding the packaging.
  • Page 6 Trim Assembly Locate the hooks on the trim to the hook bracket on the top front of the appliance. Place the 6 magnets onto the base section of the trim as shown below :- Position of 6 off magnets Fitting the Trim Infill Panels Locate the trim infill panels to the left hand and right hand sides of the trim and secure to the trim with the screws provided (2 off screws to left hand side and 2 off screws to right hand side)
  • Page 7 Operation Of The Heater Fire on / flame Fire off effect only Low heat on / off High heat on / off The heater is operated via the use of a remote control handset. A master ON / OFF switch it situated underneath the appliance on the left hand side.
  • Page 8: Safety Cut-Out

    IMPORTANT : Safety Cut Out This appliance is fitted with an automatic safety cut out. This operates if the air outlet at the top of the product becomes covered or blocked. This will prevent the fan heater from operating. In order to RESET the appliance the following procedure should be followed:- Switch OFF the appliance and disconnect the appliance from the mains supply...
  • Page 9: Maintenance

    MAINS ELECTRICAL SUPPLY. IF IN DOUBT SEEK THE ASSISTANCE OF A SUITABLY QUALIFIED PERSON. It is advisable to use genuine Flavel replacement parts available from your supplier or direct from CFM Europe Ltd. (Contact details on the rear of this booklet) Bulb Replacement Disconnect the appliance from the mains supply.
  • Page 10: Contact Information

    CONTACT INFORMATION Technical Queries 01782 339000 Service / Fault Enquires 08700 101187 The Following Information May Be Required When Contacting Flavel For Advice :- Address Postcode Model No. Serial No Fault The products serial number and model number can be found on the rating plate which is affixed to the bottom L/H side of the front panel, behind the ashpan cover.

This manual is also suitable for:

Inspire fwr**er series

Table of Contents