4 Replacement Procedures
Installing the Switch board/Fingerprint sensor board
The following describes the procedure for installing the switch board/fingerprint sensor board.
(See Figure 4-56.)
1. Connect the fingerprint sensor cable to the connector on the back of the fingerprint
sensor board.
2. Set the fingerprint sensor board in place and secure it with the following screw.
3. Connect the switch cable to the connector on the back of the switch board.
4. Set the switch board in place and secure it with the following screw.
4-102
Downloaded from LpManual.com Manuals
M2.54.0B
FLAT HEAD screw
M2.54.0B
FLAT HEAD screw
[CONFIDENTIAL]
4.32 Switch board/Fingerprint sensor board
1
1
PORTÉGÉ M780 Maintenance Manual (960-809)