Makita HR5201C Instruction Manual
Hide thumbs
Also See for HR5201C:
- Instruction manual (60 pages) ,
- Instruction manual (13 pages) ,
- Instruction manual (56 pages)
Related Manuals for Makita HR5201C
Summary of Contents for Makita HR5201C
- Page 1 INSTRUCTION MANUAL Rotary Hammer HR5201C HR5210C HR5211C 007857 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END201-5 For Model HR5201C ENG102-3 Symbols Noise The following show the symbols used for the equipment. -
Page 3: General Power Tool Safety Warnings
Vibration emission (a ) : 9.5 m/s Makita Corporation responsible h,CHeq Uncertainty (K) : 1.5 m/s manufacturer declare that the following Makita ENG303-2 machine(s): Work mode : hammer drilling into concrete Designation of Machine: Vibration emission (a ) : 17 m/s... - Page 4 Keep children and bystanders away while 15. Do not overreach. Keep proper footing and operating a power tool. Distractions can cause balance at all times. This enables better control you to lose control. of the power tool in unexpected situations. Electrical safety 16.
-
Page 5: Rotary Hammer Safety Warnings
To start the tool, simply pull the switch trigger. Release warm-up, hammering operation is difficult. the switch trigger to stop. Always be sure you have a firm footing. FOR MODELS HR5210C and HR5201C Be sure no one is below when using the tool in Trigger switch high locations. -
Page 6: Speed Change
The speed adjusting dial can be turned only as far • chisel, scaling chisel, etc. as 5 and back to 1. Do not force it past 5 or 1, or For long time hammering (FOR MODELS HR5201C the speed adjusting function may no longer work. AND HR5210C) 1. Pointer 2. -
Page 7: Side Handle
For chipping, scaling or demolition operations, depress The green power-ON indicator lamp lights up when the the lock button and rotate the change lever so that the tool is plugged. If the indicator lamp does not light up, pointer points to the symbol. - Page 8 • demolishing) when drilling in concrete, masonry, etc. The side grip swings around to either side, allowing easy 1. Lock button HR5201C handling of the tool in any position. Loosen the side grip 2. Change lever HR5210C 3. Pointer by turning it counterclockwise, swing it to the desired position and then tighten it by turning clockwise.
-
Page 9: Operation
Keep the tool in position and CAUTION: prevent it from slipping away from the hole. This servicing should be performed by Makita Do not apply more pressure when the hole becomes • Authorized or Factory Service Centers only. - Page 10 Wipe out the old grease inside and replace with a fresh and unplug the tool. grease (60 g). Use only Makita genuine hammer grease Loosen the six screws and remove the handle. Note that (optional accessory). Filling with more than the specified the top screws are different from other screws.
- Page 11 Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. SDS-Max Carbide-tipped bits • Bushing tool • Rammer •...
- Page 12 Makita Corporation Anjo, Aichi, Japan 884701C222...