Chapter 3. Basic Operation
Hot Plugging
The GCL1908 / GCL1916 supports hot plugging – components can be
removed and added back into the installation by unplugging their cables from
the ports without the need to shut the unit down. In order for hot plugging to
work properly, the procedures described below must be followed:
Hot Plugging KVM Ports
In order for the OSD menus to correspond to KVM port changes, you must
manually reconfigure the OSD to reflect the new port information. See the F3
SET (page 29) and F4 ADM (page 31), functions for details.
Note: If the computer's operating system does not support hot plugging, this
function may not work properly.
Port Selection
The GCL1908 / GCL1916 provide three port selection methods to access the
computers on the installation: Manual, OSD (on-screen display), and Hotkeys.
See Chapter 4, OSD Operation and Chapter 5, Keyboard Port Operation for
more information.
Manual Port Switching
Use the Port LED/Port Pushbuttons located on the keyboard module to switch
KVM focus to any port on the installation.
23