Yamaha TF5 User Manual page 19

BUS SETUP screen
Allows you to configure bus settings. You can change basic settings such as stereo/mono, Pan Link, etc.
These settings are included when saving a Scene.
1
AUX1/2–AUX7/8 Signal Type buttons
Determines how each pair of buses is processed. You can set each pair to be either Stereo (an odd and even numbered bus
are paired and main parameters are shared between the two) or Mono x2 (two independent mono channels).
2
AUX 1/2–AUX 7/8 Pan Link buttons
Turns pan link on and off for AUX 1/2–AUX 7/8.
These buttons are only displayed if the Signal Type of the corresponding bus is set to Stereo.
When these buttons are turned on, the pan setting of signals sent from input channels to the corresponding two buses will
link with the Stereo bus pan setting.
3
AUX 9/10–AUX 19/20 Pan Link buttons
Turns pan link on and off for AUX 9/10–AUX 19/20.
4
STEREO/SUB LINK
Determines whether the faders for the STEREO bus and the SUB bus are linked.
OMNI OUT screen
Allows you to configure the output channels that are sent to the OMNI OUT jacks.
1
OMNI OUT1–16 buttons
Allows you to select which OMNI OUT jack will be configured.
The name of the channel currently assigned to each OMNI OUT jack is also displayed in the buttons.
2
Output channel buttons
Determines which output channel or monitor output will be assigned to the OMNI OUT jack you selected for
If you select None, nothing will be output to the corresponding OMNI OUT jack.
- 19 -
Toolbar
1
.
User Guide
TF Editor