Hardware Installation; Installation Instructions; Precautions - Motorola AP-7532 Installation Manual

8
2

Hardware Installation

2.1 Installation Instructions

An AP-7532 Access Point mounts either on a wall (with M 3.5 x 0.6 x 23 MM pan head screws and mounting
bracket- or equivalent) or on a suspended ceiling T-bar.
To prepare for the installation:
1. Match the part number on the purchase order with the part numbers in the packing list and on the case
of the Access Point.
2. Verify the contents of the box include the intended AP-7532 Access Point, and the included hardware
matches the package contents (see
Part Number
AP-7532-67040-US
AP-7532-67040-WR
AP-7532-67040-EU
AP-7532-67030-US
AP-7532-67030-WR
AP-7532-67030-EU
3. Review site survey and network analysis reports to determine the location and mounting position for the
AP-7532 Access Point.
4. Connect a CAT-5 or better Ethernet cable to a compatible 802.3at or 802.3af power source and run the
cable to the installation site. Ensure there is sufficient slack on the cable to perform the installation
steps.
NOTE

2.2 Precautions

Before installing an AP-7532 Access Point, verify the following:
• Your are using the correctly rated power solution for the AP-7532 (either the AP-PSBIAS-2P3-ATR power
injector or the PWRS-14000-54R external power supply)
• Motorola Solutions recommends you do not to install the AP-7532 in wet or dusty areas.
• Verify the environment has a continuous temperature range between -4° F to 104° F/-20° C to 40° C for
external antenna Access Points and 32° F to 104° F/0° C to 40° C for internal antenna Access Points.
AP-7532 Package Contents on page
AP-7532 dual radio 802.11ac 3x3:3 MIMO Access Point external antenna US version
AP-7532 dual radio 802.11ac 3x3:3 MIMO Access Point external antenna International version
AP-7532 dual radio 802.11ac 3x3:3 MIMO Access Point external antenna EU version
AP-7532 dual radio 802.11ac 3x3:3 MIMO Access Point internal antenna US version
AP-7532 dual radio 802.11ac 3x3:3 MIMO Access Point internal antenna International version
AP-7532 dual radio 802.11ac 3x3:3 MIMO Access Point internal antenna EU version
When operating in a Gigabit Ethernet environment, CAT-5e or CAT-6 cable
is recommended for Gigabit operation.
Description
AP-7532 Access Point
6)
.