Specifications / Technische Daten - Electro-Voice P900RL Owner's Manual

- System (amplifier) at rated conditions, both channels driven, 8Ω loads, unless otherwise specified.
- Depending on the ambient temperature, the unit might not operate continuously at 2Ω load.
Load Impedance
Maximum Midband Output Power
THD = 1%, 1kHz
Rated Output Power
THD < 0.2%, 20Hz ... 20kHz
Max. Single Channel Output Power
Dynamic-Headroom, IHF-A
Maximum RMS Voltage Swing
THD = 1%, 1kHz
Power Consumption
at 1/8 maximum output power @ 4Ω
THD at rated output power,
MBW = 80kHz, 1kHz
IMD-SMPTE
60Hz, 7kHz
DIM30
3.15kHz, 15kHz
Crosstalk Attenuation
ref. 1kHz, at rated output power
Frequency Response
-1dB, ref. 1kHz
Damping Factor
at 100Hz / 1kHz, 8Ω
Signal to Noise Ratio, Amplifier
A-weighted
Signal to Noise Ratio, System
A-weighted
Input Sensitivity
at rated output power @ 4Ω, 1kHz
Max. Input Voltage
Input Impedance
20Hz ... 20kHz, balanced
CMR
1kHz
Output Voltage
DSP OUT / Monitor
Output Impedance
DSP OUT / Monitor
Minimum Output Load
DSP OUT / Monitor
AD & DA Conversion
Sample Rate
Internal Wordlength
Dynamic Range
Functions

SPECIFICATIONS / TECHNISCHE DATEN

P900RL
8Ω 4Ω
2x 2x
280W 450W
2x 2x
175W 350W
340W 640W
56V
690W
rated: +6dBu (1.55V)
max: +21dBu (8.7V)
Digital Signal Processing
24 Bit, Sigma-Delta, 128 x Oversampling, Linear Phase
Volume Control, Routing,
X-Over
(6, 12, 18, 24 dB/Oct Slope, Butterworth, Bessel, Linkwitz-Riley)
Filter
(Parametric EQ, Lo / Hi Shelving EQ, LPN, Lo / Hi Pass, Allpass)
Compressor / Limiter, Delay
29
P1200RL
2Ω 8Ω 4Ω
2x 2x 2x
650W 380W 600W
2x 2x
-
250W 500W
720W 460W 880W
64V
870W
< 0.05%
< 0.08%
< 0.03%
> 80dB
15Hz ... 22.5kHz
> 300 / > 200
106dB
100dB
+6dBu (1.55V)
+21dBu (8.7V)
20kΩ
80dB
< 100Ω
600Ω
48kHz
48 bit
115dB (typical)
2Ω
2x
850W
-
950W
,
,