Table of Contents
Advertisement
Error/Code
37 Insufficient Memory
38 Memory Full
39 Complex Page
43 Font Card Not Supported
44 Defective Font Card
47 Font Card Removed While Printing
52 Flash Full
53 Unformatted or Defective Flash
54 Serial Error
58 Duplex Not Attached
59 Duplex Cover Open
62 Disk Full
6
Service Manual
Action
Not enough memory for function
requested.To verify that the printer
recognizes all the installed memory, go
to the user menus and print the "Print
Menus" test page. Make sure the
memory shown on the printout matches
the installed memory.
Memory used to store pages is full.To
verify that the printer recognizes all the
installed memory, go to the user menus
and print the "Print Menus" test page.
Make sure the memory shown on the
printout matches the installed memory.
Page too complex to print.To verify that
the printer recognizes all the installed
memory, go to the user menus and print
the "Print Menus" test page. Make sure
the memory shown on the printout
matches the installed memory.
Font card format not supported by
printer.
Defective font card installed in font slot.
Printer needs data on removed card.
Not enough flash memory for data
requested to be stored.
Flash problem at POR or while
attempting to write.
Framing or parity error on serial.
Duplex is electrically connected but no
longer mechanically attached, and
printer top cover is closed.
Top cover of duplex unit is sensed open.
Not enough disk space for data that has
been requested to be written to disk.
Advertisement
Table of Contents
