Using The Projector And Remote Control; Preparations; Turning The Power On; Switching Input Signals - BenQ PE5120 User Manual

Using the projector and remote control

Preparations

1. Turn all of the connected equipment on.
2. Remove the lens cap.

Turning the power on

1. Check that the Power indicator lights orange after power has been
applied.
2. Press and hold the Power button on the projector or remote
control to turn the projector on. The Power indicator light flashes
for about 30 seconds during warm up, then remains constantly
on (and the projector starts projecting) when ready.
3. Press Source on the projector or one of the Source buttons on the
remote control to select your desired input signal. A message
shows on the screen when the port is searched.
If you would like to change the input signal, please see below.

Switching input signals

To sequentially select input signals, press one of the Source buttons on
the remote control or Source on the projector.
The selected source will be displayed at the bottom right of the screen
for 3 seconds.
Activate the Source Scan function in the Advance menu if you want the
projector to automatically search input ports. It may take a few seconds for
the projector to search for input signals.
20 Using the projector and remote control
3. Plug the supplied power cord into the AC inlet on the
rear of the projector.
4. Plug the power cord into a wall socket and turn the
wall switch on.