Table of Contents
Advertisement
PE7700-e.book Page 19 Monday, January 10, 2005 11:20 AM
Using the projector and remote control
Preparations
1.
Turn all of the connected equipment on.
2.
Remove the lens cap.
Turning the power on
Follow the steps below.
1.
Make sure the Power light is orange after power has been applied and the
main AC power switch is turned on.
2.
Press and hold the POWER button on the projector or remote control to
turn the projector on.
The POWER button may not work while the projector is warming up.
3.
The fans will be up and running. A start-up image shows on the screen for
a few seconds.
4.
" Searching...." will be displayed on the screen before the projector
identifies the input signal. This message will remain on the screen until a valid signal is detected.
5.
If the horizontal frequency of the input signal exceeds the range of the projector, a message reading "
Unsupported timing" will be displayed on the screen. This message will remain on-screen until you
change the input signal.
Switching input signals
The projector can be connected to multiple equipment at the same time. To
sequentially select input signals, press one of the Source buttons on the remote
control or SOURCE/ENTER on the projector.
When the projector is turned on, it will search for the input source you
last selected.
If you need to use the PIP or POP function, refer to page
operation.
3.
Plug the supplied power cable into the AC inlet on the
rear of the projector and turn the main AC power
switch on.
4.
Plug the power cable into a wall socket and turn the
wall switch on.
22
for advanced
Using the projector and remote control
http://www.pureglare.com.au
19
Advertisement
Table of Contents
