Advertisement
HOW TO INSTALL REMOTE SHIFTER
RDA2429-R model ONLY
The R model has a convenient remote shifter lever.
You can install it on the handlebar or stem, then you can control
the resistance level without getting off the bike.
The clamp band is made of thin and flexible soft plastic so it can
be installed on aerodynamic shape handlebar or oval dimension
stem.
!
If your handlebar has quite special shape
or the stem is square dimension type, the
remote shifter cannot be installed.
Installing Remote Shifter:
1) Pull down the lever and release the clamp band from the hook.
2) Wind the band around handlebar or stem.
3) Put the band tip to the hook.
4) Pull up the lever to tighten the band.
The flexible plastic band is pre-adjusted to fit normal 22mm diameter
handlebar.
If you need to mount onto an oversized or specially shaped handlebar
or stem, adjust the band by turning the plastic screw on the band with
an M4 hex wrench (see Fig. M).
(Please be advised that this hex wrench doesn't come with the kit.
Prepare by yourself.)
!
Both clamp band and screw are made of plastic so they are fragile.
You should take off the hook to prevent from the breakage of those plastic parts.
HOW TO ADJUST CABLE TENSION
If you get unable to set at L or H even though you operate the remote shifter lever, it's the time to adjust
the cable tension. Follow the steps below;
1) Straighten the cable as much as possible, and set the shifter at "H" position.
2) Pull out the small black plastic cap on the cable, then an adjusting screw gets exposed.
3) Put the black outer cable to the remote shifter, and put the adjusting screw to the outer cable.
4) While keeping this position, screw the lock nut toward the Mag unit until it touches the plastic parts.
5) Put the black plastic cap on.
Required Tool: M4 Hex Wrench
1
Hook
2
Lever
(Fig. K)
Clamp Band
(Fig. L)
(Fig. M)
Advertisement
