Advertisement
HOW TO SETUP RDA2429 TRAINER
Fully open the legs and place RDA2429 on a flat and horizontal floor.
1
Confirm all 4 leg points are touching the floor at same time to ensure the maximum stability.
NOTE: If legs are uneven when first opening the trainer, make sure both legs are fully
extended.
Install the Mag Resistance Unit on the left side
2
slot beside the trainer pillar by the supplied
M6x18 bolts (SR-12) and the small plate (SR-13).
(see Fig. A)
Assistant Roller is set on the right side slot.
NOTE: You must use the Reinforcement Plate
(SR-13) for installing the Mag unit.
This plate will sandwich the slot plate
from outside for mounting the heavy
Mag unit and giving it extra stability.
You don't need to tighten the bolts
firmly yet. it will be done later.
Open both couplings by turning the left side Knob (see Fig. B) and the right side Hub Handle (see
3
Fig. C) anti-clockwise.
Left Side Adjust Knob
NOTE: Do not over-loosen the couplings, otherwise the knob or the hub handle may be-
come unthreaded inside the frame.
NOTE: Please note that the left side knob is not for tightening the wheel hub but for pre-
adjusting the wheel position in order to stabilize the roller pressure to the rim.
Once you have set up the position, you basically no longer re-adjust the knob
while using the same wheel.
Push the right side Tension Lever (ER-14) and the left side Pressure Lever (ER-10) to retract the
4
rubber rollers to make enough space for installing the tire.
NOTE: If it's hard to retract the arm, assist with another hand to pull the roller.
Insert the left side of the skewer (Q/R lever side) into the left
5
side coupling, and adjust the rotation of the coupling so the
skewer lever sits securely in the large cut-out (see Fig. D).
NOTE: Failure to do so may cause the bike to be loose in the
coupling, possibly causing the bike to fall out of the
stand resulting in damage or injury.
(Fig. B)
Required Tool: M5 Hex Wrench
Right Side Hub Clamp Hadle
(influded)
(Fig. A)
(Fig. C)
(Fig. D)
Advertisement
