Assembly; Operations; Charging; Using Cordless Vacuum - Bissell BOLT ION User Manual

Assembly

No tools are required for assembly; simply insert
foot into body of unit until you hear a click.

Charging

Before charging make sure unit is in the OFF
position.
1. Insert the charging adapter plug into the
charging port on the bottom of the charging
base. The unit can also be charged from the
hand vacuum by inserting the charging adapter
plug into the charging port on the back of
the unit.
2. Plug the adapter into the wall outlet. If using
the charging base, place unit onto base. The
power LED lights will illuminate when charging.
Charge the unit completely for 4 hours prior to
first use.
NOTE: The adapter may become warm during
charging – this is normal.
3. When the unit is fully discharged,
approximately 4 hours of charging is required
for the battery to regain full capacity.
Battery Status LED Color
100% Blue
99% to 66% Blue
65% to 33% Blue
32% to 10% Blue
9% to 1% Red
0% Red

Operations

Control buttons

The power button is located on the top
of the handle. Settings include:
a. Power Icon = On/Off
b. Brush Icon = Brush On/Off
c. Suction Icon = Normal/High
d. EdgeReach = On/Off
Using your cordless vacuum
1. Push power button ON.
2. Push brush button on to easily clean
hard floors, low pile carpet, and area rugs.
3. Use suction button to control power
of suction.
Charging
Light Behavior
3 Lights On, for 10 minutes
2 Lights On, 1 Light Blinking, 2 Second Fade In & Out
1 Light On, 1 Light Blinking, 2 Second Fade In & Out
1 Light Blinking, 2 Second Fade In & Out
1 Light Blinking, 1 Second Fade In & Out
1 Light Blinking, 1 Second Fade In & Out
WARNING
Do not plug in your vacuum cleaner until
you are familiar with all instructions and
operating procedures.
1.
a. b.
c. d.
www.BISSELL.com
5