Superior VRE4336ZEN Installation Instructions Manual page 16

Step 6. (Refer to Figure 19 on page 15 )
A. Remove the orifice from the manifold with
a 1/2" deep throat socket. See the following
table for orifice sizes for natural and propane
models. Figure 22 illustrates the orifice. Use
pipe joint compound or Teflon tape on all
pipe fittings before installing (ensure propane
resistant compounds are used in propane ap-
plications, do not use pipe joint compounds
on flare fittings).
B. Retrieve the burner and slide the venturi tube
over the orifice. Secure the burner in place with
the clip shown in Figure 19.
Step 7. Reassemble the remaining components
by reversing the procedures outlined in the
preceding steps.
IHP reserves the right to make changes at any time, without notice, in design, materials,
specifications, prices and also to discontinue colors, styles and products. Consult your
local distributor for fireplace code information.
Printed in U.S.A. © 2014 IHP LLC
P/N 506009-24 REV. NC 03/2014
16
Pilot Stage
Terminal
Ground
(TP)
Gas Outlet
To Burner
Burner Stage Regulator
Terminal Mounting Screw
Figure 20
ELECTRONIC PILOT
Sensor
Igniter
PROPANE
NOTE: If the igniter is damaged, a re-
placement kit is available, order Catalog
Number 87L54.
Figure 21
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
P506009-24
Pressure-Tap
(Inlet)
HI
LO
Pressure-Tap
(Manifold)
Elevation 0-4500 feet ( 0-1372 meters)
Pilot
Model
Hood
VRE4336
VRE4342
Figure 22
NATURAL
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
Pilot Gas
Outlet
Supply
Gas
Inlet
Burner Orifice Sizes
Nat.Gas Propane
drill size (inches) drill size (inches)
#28 (.1405") #47 (.0785")
#28 (.1405") #47 (.0785")