Infrared Remote Controller Installation Manual - Panasonic S-22KA1E5 Service Manual

11.11 INFRARED REMOTE CONTROLLER INSTALLATION MANUAL

CZ-RWS1
CZ-RWC1
•
Before installing the infrared remote controller, be sure to thoroughly read the "Precautions in terms of safety"
section of the installation manual provided with the indoor unit.
•
After installing the infrared remote controller, carry out a test operation to check that the remote controller
functions properly and also explain the operation and cleaning procedures to the customer in accordance with
the details in the instruction manual. Furthermore, ask the customer to keep this installation manual and the
operation instruction in a safe place for later reference.
11.11.1 ACCESSORIES SUPPLIED WTH THE INFRARED REMOTE CONTROLLER
No.
○
Infrared Remote Controller
1
○
R03 battery
2
○
Holder
3
11.11.2 INFRARED REMOTE CONTROLLER OPERATION
•
The infrared remote controller can be used to operate indoor units at a maximum range of 8 meters from directly
in front of the indoor unit.
•
If the remote controller is at an angle to the receptor unit, the operating range may become shortened.
•
If using a single remote controller to operate several air conditioners, address setting will be required.
•
(To be discussed later.)
INFRARED REMOTE CONTROLLER INSTALLATION PROCEDURE
(Use the holder to store the remote controller.)
The remote controller can be installed to the wall.
○ Secure the holder with the screws provided. (2 screw
1
locations)
○ Insert and remove the remote controller by sliding it in/out
2
from the top of the holder.
Note
•
The holder should be in a place where it is not exposed to any type of heat (such as direct sunlight or near a
stove).
•
The remote controller may not transmit to the receiver properly while it is in the holder. Be sure to remove the
remote controller unit from the holder and face the receiver when operating it.
(Cooling/Heating)
(Cooling only)
Name
Ø 4 mm
pan screw
Qty. No.
○
1 Holder fixing screw
4
2
Installation manual (This manual)
1
Transmitter
4 mm pan screws (accessory)
Be sure to only use the accessory
screws, otherwise the remote
controller may become damaged.
138
Name
LCD
ON/OFF switch
Cover
Remote controller holder
Secure the remote controller
holder to the wall using the 4
mm pan screws (accessory).
Qty.
2
1