Rear Anti-Tippers; Amputee Kit; Safety Belt; Spoke Guards - Invacare Zipper 2 User Manual

15. Rear Anti-tippers

Photograph 22
The anti-tippers help prevent you from tipping over when the rear
wheels are incorrectly positioned, or when the user or attendant
mishandles the wheelchair.
- Use: The anti-tippers fit into the rear tubes of
the side frames (A). Fit the anti-tippers into the
side frame rear tube, until the button springs are
positioned in the holes of the rear tube (A). Carry
out these operations in the reverse order to
remove. You can leave the anti-tip casters on the
wheelchair even if you do not wish to use them.
Just depress the button spring and rotate the
entire anti-tipper unit a half turn. (180 deg.)
- Note: The anti-tippers are not to be used as tipping levers.
16. Transit kit
Photos 23 and 24
The transit kit includes a manual brake for operation by an
attendant.
Note: - This brake is different to the self propelled version.
Also included is a choice of either pneumatic or solid tyred
wheels.
- Adjustment: It may be necessary to adjust the
brakes after repairing a puncture or because of wear
on the pneumatic or solid tyre. Slacken clamp screws
(B) and adjust the brake assembly to achieve
adequate braking. Tighten the clamp screws (B)
firmly after adjustment.
The pressure of the pneumatic tyres should be checked
before use of the wheelchair. The pressure is shown on
the tyre and must never be exceeded.
puncture, the tyre may have to be removed from the rim. Press the valve to
let all the remaining air out of the inner tube. Remove the tyre off the rim.
Repair or replace the inner tube. Put the tyre back on the rim. Inflate the tyre
to the required pressure.
28
22
A
B
23
24
B
In case of a
- Note: It may be necessary to use one or two tyre removal tools (not
supplied). The tyre pressure on both wheels should be the same.

17. Amputee kit

Photograph 25
The amputee kit makes it possible for the manually
propelled wheelchair to be operated by people whose
centre of gravity is further back while allowing the
wheelchair to be used with less restrictions than with
anti-tippers. The kit should be fitted and adjusted by
a qualified technician.
18. Tray
Photos 26 and 27
- The tray mounting brackets can be fixed under the
armrest pads.
- Use: The tray can be positioned towards the front or
back without locking.
The tray can folded to the left or right for frontal transfers
only.
The tray requires no adjustment.
Note: Do not move the wheelchair with the tray folded
aside.

19. Safety Belt

The strap can be adjusted by the user with a buckle
system.
A qualified advisor must show you how to position the strap according to
your needs.

20. Spoke guards

The spoke guards must be assembled by a qualified technician.
The spoke guards do not require any adjustment.
25
26
27
29