Leveling And Stabilizing Your Dryer - GE GTMP280EDWW Use And Care Manual

Electric Dryer
STANDARD REAR EXHAUST
ELBOW HIGHLY
RECO ENDED
NOTE: ELBOWS WILL PREVENT DUCT
KINKING AND COLLAPSING.
LEVELING AND STABILIZING YOUR
5
DRYER
Stand the dryer upright near the nal location and
ad ust the 4 leveling legs, at the corners, to ensure that
the dryer is level from side to side and front to rear.
LEVEL
FRONT-TO-BACK
4 LEVELING
LEGS
ELBOW HIGHLY
RECO ENDED
RECO ENDED
CONFIGURATION
TO INI I E
EXHAUST
BLOCKAGE.
LEVEL
SIDE-TO-SIDE
USING FLEXIBLE METAL DUCTS
If rigid all-metal duct cannot e used, then exi le all-metal
ducting can e used, ut it will reduce the maximum
recommended duct length. In special installations when it is
impossi le to use only metal ducting, then UL-listed clothes dryer
exi le metal transition duct may e used as transition venting
etween the dryer and wall connection only. The use of this
ducting will affect dry time.
If exi le transition duct is necessary, the following directions
must e followed.
Use the shortest length possi le.
Stretch the duct to its maximum length to avoid kinks.
Do not crush or collapse the duct.
Extend vent protection racket as descri ed in step 1.
Never use transition duct inside the wall or inside the
dryer on page 2.
Avoid resting the duct on sharp o ects.
ELBOW HIGHLY
RECO ENDED
ELBOW HIGHLY
RECO
DO NOT USE
EXCESSIVE
EXHAUST
LENGTH
www.GEAppliances.ca
DO
ENDED
DON'T
DO NOT SIT
DRYER ON
FLEXIBLE
EXHAUST
DO NOT
CRUSH
FLEXIBLE
EXHAUST
AGAINST
WALL
9