Maintenance; Recommended Maintenance Schedule(S); Preparing For Maintenance - Toro 20381 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
Before each use or daily
Every 25 hours
Before storage
Yearly

Preparing for Maintenance

1. Stop the engine and wait for all moving parts to stop.
2. Remove the electric-start button; refer to Figure 14
(electric-start model only).
3. Disconnect the spark plug wire from the spark plug
(Figure 32) before performing any maintenance
procedure.
1
Figure 32
1. Spark-plug wire
4. After performing the maintenance procedure(s),
connect the spark plug wire to the spark plug.
5. Insert the electric-start button in the starter
(electric-start model only).
Important: Before tipping the machine to change
the oil or replace the blade, allow the fuel tank to
run dry through normal usage. If you must tip
the machine prior to running out of fuel, use a
Maintenance Procedure
• Change the engine oil.
• Check the engine oil level.
• Ensure that the engine stops within 3 seconds after releasing the blade-control bar.
• Clean grass clippings and dirt from under the machine.
• Charge the battery.
• Lubricate the rear wheel gears.
• Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
• Charge the battery.
• Empty the fuel tank before repairs as directed and before annual storage.
• Replace the air filter; replace it more frequently in dusty operating conditions.
• Change the engine oil.
G017466
hand fuel pump to remove the fuel. Always tip the
machine onto its side with the air filter up.
WARNING
Tipping the machine may cause the fuel to
leak. Gasoline is flammable, explosive and
can cause personal injury.
Run the engine dry or remove the gasoline
with a hand pump; never siphon.
17