Table of Contents
Advertisement
"Memory repeat" indicator
By simply designating the beginning ("0000') and the end of the
part that you want to play repeatedly, that part can be repeatedly
played for as many as 16 times.
(This repeat-play feature can be used only in the playback mode.)
I
I
Press the playback button.
(The playback indicator will illuminate, and playback will
begin.)
2
Press the counter-reset button at the place (A) where you
want the repeat play to stan.
(The counter will be reset to "0000".)
\t
Press the memory-repeat button at the place (B) where
you want the repeat play to end.
(The memory-repeat indicator will illuminate.)
When the memory-repeat button is pressed, the tape will be
rewound to point (A), and the repeat play will then begin.
volume control
I
I
Set the headphones volume control to low posltion
before connecting headphones.
Z
Connect headphones (not included) to the headphones
jack.
\t
Use the headphones volume control to adjust the volume
while listening to music.
Plug type: 6 mm (%") phone plug, stereo type.
Note:
Avoid listening for a long time that it irritates the ears.
The unit is equipped with the automatic-tape-select
feature; it
automatically detects the type ol tape being used, and then makes
the suitable adjustments accordingly of the bias and equalization.
(The tape-select indicator will illuminate.)
Place where counter-reset
button was pressed
A: "0000"
Place where memory-repeat
button was pressed
B
I
Tape
Repeat play (16 times) of this part
)To
cancel the repeat-play function before it stops (after 16
repeats), press the memory-repeat button.
(The memory-repeat indicator will switch OFF.)
)To change the setting of point (B), first cancel the repeat-play
operation (see above), and then press the memory-repeat button
at the new place.
Notes:
oThe repeat-play function will be cancelled if the stop bufton or the
rewind/fast-foryvard/search button is pressed during repeat play.
To stop temporarily, press the pause button.
.Repeat play is possible while either the tape counter or lhe linear
counter is displayed, but a change from one to the other cannot
be made while repeat play is in progress.
.lf, after setting point (A), the tape is rewound to set point (B), the
repeat play will be of the part between the tape beginning and
point (B).
(The linear counter reading will be a minus reading.)
Tape
Repeat play (16 times) of this part
oThere may be a slight ditference (maximum +4 seconds)
between the settings made for points (A) and (B) and the points at
which the tape is actually played during repeat play.
- 9 -
Hide quick links:
Advertisement
Table of Contents
