Recording - Technics RS-B655 Operating Instructions Manual

Recording
2@
l-
$vvit6ft OFF the timer switch.
Q F.'*I
\., Swiich ON the power "standby O /on"
switch.
4
@**
the eject button, and then insert the
cassette to be used for recording.
(The part of the
tape is exposed
ward.)
1
Switch the amplifier ON, and select the
I input source.
8 ffihe
recordins tevet.
noise-reduction system (B or C) to be used.
[Ihe Dolby noise-reduction
("8" or "C") indicator will illumi-
nate.l
lf neither Dolby noise-reduction system is to be used, press
the Dolby noise-reduction button corresponding to the Dolby
noise-reduction indicator that is illuminated. ffhe indicator will
then switch OFF.)
The sound source to be recorded should
be played before the recording is started
in order to adjust the recording level.
11
I To temporarily stop recording
lFausel Press the pause button.
(The playback indicator will begin flashing.)
To resume recording, press the playback button.
I To stop recording
lstopl Press the stop button.
Adjust so that the indication of the input level meter
occasionally is as high as shown below.
Normal tape
CrOa tape
Metal lape
o D o l b y N R B . C
oNR off
D0t+gl
+ 6
For additional precision of the recording level
adiustment
Press the meter-range selector to display -7 to +8 of
the input level meter.
(The level will be displayed in 1 dB increments.)
Press the playback button.
(The playback indicator will illuminate steadily, and the
recording will begin.)
cassette where the
should face down-
I
tr Foise redffiionl
\.' Fress the button corresponding to the Dolby
q Faa"dl
v
Adiust the lefUright volume balance.
1 n
Stop the play being done so as to adiust
I v
the recording level, and begin playing the
source once again. sound
@
7 H"" the record button.
(The recording indicator will illuminate and the playback
indicator will flash continuously; the unit will be in the
recording stand-by mode.)
- 1 0 -