Technics RS-B655 Operating Instructions Manual page 8

Technics rs-b655 stereo gassette deck
Table of Contents

Advertisement

Playback
(conrinued)
I To find a tune's beginning
("music select" function)
Press the rewind/fast-fomard/search button du rin g playback.
After the tune's beginning is located, the tune will begin playing.
(The playback indicator will flash rapidly while the tune's beginning
is being located.)
(for previous tune if pressed again)
To locate a certain tune that is several tunes before (or after) the
tune now playing, repeat the same steps as many times as
necessary.
Note:
Note that this feature might not function correctly under the
following circumstances:
.lf there is noise between tunes.
.lf the silent interval between tunes is less than 4 seconds.
olf there is a particularly low level of sound, or a silent interval, at
any place within the tune.
.lf less than 10 seconds separate the program you are listening to
and the next program.
Music select system manufactured under license of Starr
S.A., Bruxelles, Belgium.
I To fast-foruvard or rewind the tape
While in the stop mode, press the appropriate button according to
the following figures.
EEis
.d
.
"@
d--&o
,.#
MAb
-BlrEEft*ac
-
- - -
T ; l [ " T r . n
The tape is rewound to the designated point and then play can be
begun from that point.
To set the playback start point
Press the memory-stop button and then begin the
playback.
(The memory-stop indicator will illuminate.)
Press the counter-reset button at the point to which you
want the tape to rewind.
(The counter will be reset to "0000".)
To begin playback from the set point
.t
Press the stop button.
A
+
Press the rewind ({{)
button.
The tape will be rewound to the set point, and then will be
automatically stopped.
5
Press the playback button to begin the playback once
again.
)To cancel the "memory stop" function, press the memory stop
button once again.
(The memory stop indicator will be swilched OFF.)
Notes:
.The "memory stop" function can be used while either the tape
counter or the linear counter is displayed, but a change lrom one
to the other cannot be made during the "memory stop" mode.
oThere may be a slight difference (maximum +4 seconds)
between the point where the tape counler was reset and the point
where the lape actually stops during rewind.
2
- 8 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents