Recall Stations From Preset Memories; Display Backlight - Sangean Toughbox TB-100 Instruction Manual

Memory presets stations
Storing stations in preset memories, please follow below step.
There are 5 memory presets for each waveband.
1. Press the Power button to turn on the radio.
2. Tune to required station pressing Band button and
Tuning Control.
3. Press and hold down the required preset until the radio beeps.
The preset number will appear in the display and the station will
be stored under chosen preset button.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be over written by
following above procedures.

Recall stations from preset memories

1. Press the Power button to turn on the radio.
2. Select the required waveband.
3. Momentarily press the required Preset button, the preset
number and station frequency will appear in the display.

Display backlight

When radio is switched on, press any button except Power button
will illuminate the LCD display for approx. 15 seconds.
GB
8