Presetting Stations - Sangean PR-D19 Manual

Manual tuning - AM / FM
. Press the Power button to switch on your radio.
2. Press the Band button to select the required band. Fully extend
the antenna for best reception.
3. Press and release the Tuning up/down button to tune to a station.
The FM frequency will change in steps of 50/00kHz and AM
frequency will change in steps of 9/0kHz.
4. When the waveband end is reached the radio will recommence
tuning from the opposite waveband end.
5. Set the Volume using the Volume Up/Down buttons to the desired
settings.

Presetting stations

You may store your preferred AM/FM radio stations to the preset
stations ( to 5). The procedure for setting preset Stations is
described below.
Note that the radios for AM (AM/AM2) and FM (FM/FM2) are
saved together in the preset stations so there are 20 of them. Your
preset stations will be preserved for 30 minutes when there is no
power supply from either the battery or the AC adapter.
. Press the Power button to switch on your radio.
2. Tune to the required station as previously described.
3. Press and hold the required Preset button (-5) until you hear a
beep sound and the display shows'M' for example on the top right
corner. The station will be stored using the preset number. Repeat
this procedure for the remaining presets as you wish.
4. Preset stations which have already been stored may be overwritten
by following the above procedure if required.
9