Disassembly - Pioneer XV-EV1000 Service Manual

1

7.1.11 DISASSEMBLY

Note 1: Do NOT look directly into the pickup lens. The laser beam may cause eye injury.
Note 2: Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
A
described here are common.
Note 3: For performing the diagnosis shown below, the following jigs for service is required:
• Flexible cable for service (GGD1309)
• Cable for service (GGD1425)
Diagnosis of PCB's
1
Bonnet and Tray panel
1
Remove 4 screws from Bonnet L and R (BPZ30P080FNI).
B
2
Remove 2 screws from Bonnet L and R (BBZ30P080FNI).
3
Remove the Bonnet by removing the 8 screws
(BBZ30P080FNI).
3
C
4
Press the STANDBY/ON button to turn on the power.
D 5 Press the 0 OPEN/CLOSE button to open the Tray.
6
Remove the Tray Cap Assy.
7
Set the Test Disc.
E
7
Test Disc
6
Tray Cap Assy
5
8
F
112
1
2
8
9
10
How to open the tray when the power cannot be on
Insert a Tweezer(as shown in the photo) into the slit located at
the bottom of the unit and slide the projection of the Drive Cam in
1
the Loader Assy in the direction of the arrow, as indicated in the
photo.
If the tray pops out a little, fully pull it out by hand.
2
Rear View
4 9
5 8
XV-EV1000
2
3
Press the 0 OPEN/CLOSE button to close the Tray.
(Test disc is clamped.)
Press the STANDBY/ON button to turn off the power.
Pull out the Power cord.
Tweezer
Bottom View
3
4
Slit
4