D-Link DIR-640L User Manual page 31

Section 3 - Configuration
Choose 3G if you are connecting from a mobile wireless network with an ISP that uses a 3G connection.
My Internet
Connection Is: Select 3G from the drop-down menu.
Dial-Up Profile: In most cases you can choose Auto-Detection to get a connection.
Otherwise choose Manual and personalize the settings below.
Country:
Choose the country where you get 3G service from the drop-down menu.
Telecom
Choose the telecom that provides your service from the drop-down
menu.
3G Network: Choose the type of 3G network you have from the drop-down menu.
User Name: Enter your 3G network user name, this is not always required by your ISP.
Password: Enter your 3G network password and then retype the password in the
next box. This is also not always required by your ISP.
Dialed Number:
Enter the number your ISP gave you to dial for a connection.
Authentication:
Choose the type of authentication need to connect or use auto detection.
APN:
If your ISP has given you an Access Point Name to use for your connectivity, you may enter it here.
Reconnect Mode: Select either Always-on, On-Demand, or Manual.
Maximum Idle
Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable
Time: Auto-reconnect.
DNS Addresses: Enter the primary and secondary DNS server addresses (static PPPoE only).
Keep Alive: To keep prevent inactivity from assuming a dropped connection you can select Use LCP Echo Request to request frequent pings
to maintain communication. This is disabled by default.
D-Link DIR-640L User Manual
3G
26