Brother P-touch E300 User Manual page 51

Message
記憶體已滿，
無法儲存！
輸入的
位數不足 !
首尾請輸入
A,B,C, 或 D!
最多可輸入
５個條碼 !
字體大小
過大 !
色帶錯誤！
系統錯誤 !
請更改
兩端空白設定 !
已達列印極限！
每個色帶
最多 100 行
段落功能
無法使用 !
已達列印極限！
最多 2 行
此功能需要
9mm 之標籤帶
或更寬的色帶！
編輯時
無法使用
排序功能 !
標籤帶類型
不符合
要繼續嗎 ?
查無此碼 !
There is not enough internal memory available when you try to save
a label file. Delete any unnecessary files to make more memory
available for the new label file.
The number of digits entered in the 條碼 data does not match the
number of digits set in the 條碼 parameters. Enter the correct number
of digits.
The 條碼 data entered does not have the required start/stop code
(A, B, C, or D required at the beginning and end of the 條碼 data for
the CODABAR protocol). Enter the 條碼 data correctly.
There are already five 條碼 entered in the text data when you try to
enter a new 條碼 . You can only use up to five 條碼 in each label. You
can enter up to two 條碼 when (AA|AA) is selected in flag layout.
The text size is too large. Select a different size option.
Installed tape is incompatible with this labelling system. Use
compatible tape.
Please contact Brother customer service.
The tape length set using the tape length setting is shorter than the
total length of the left and right margins applied for the "Large Margin"
cutting option. You have to select a different cutting option.
Exceeds max. You can enter up to 100 lines in the whole page and
blocks.
In this setting, you cannot add or delete blocks.
PUNCH-DOWN BLOCK layout allows to print up to 2 lines / block.
PUNCH-DOWN BLOCK layout must use 9mm or wider tape
cassettes.
Texts cannot be edited when you set Sequence Type in PUNCH-
DOWN BLOCK to Horizontal or Backbone.
For example, Heat Shrink Tube cartridge is detected but Heat Shrink
Tube mode is not selected, or Heat Shrink Tube mode is selected but
the Heat Shrink Tube cartridge is not inserted into the P-touch
labelling system.
There is no conversion candidate. Please confirm the text inputted
and transform again.
Cause/Remedy
1
2
3
4
5
6
7
8
9
49
Error Messages