Reset To Factory Settings; Code Identification - GE 25007 Instruction Manual

Using Your Remote, cont.
setup
cbl
1
3
2
4 6
5
7 9
8
0
setup
0
3. Press and release the MUTE button.
4. Press and release the VOL - button.
The red indicator light will blink twice
and go off.

Code Identification

1. Press and hold the SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the desired device
button (TV, CBL, DVR, B-RAY, SAT,
AMP, AUX 1, AUX 2) you would like the
code for.
3. Press and release ENTER button.
4. Press and release the #1 button.
Count the number of times the
remote light flashes. This is the
number corresponding to the first
digit of the code. Repeat the process
by pressing the #2, #3 and #4
buttons for the remaining digits.
5. Press and release ENTER button to
exit this mode.

Reset to Factory Settings

1. Press and hold the SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the MUTE button.
3. Press and release the number #0
button. The red indicator light will
flash twice.
13