In-Ceiling Mount (Open Type) - Sanyo VCC-9500 Installation Manual

In-ceiling Mount (Open Type)

Make sure to also consult the In-ceiling Bracket Open Type Instruction Manual.
1. Installing the power board unit
1
Drill a hole (φ196 mm/7.7") in the ceiling for
installing the in-ceiling bracket.
● Pull out the cables from the ceiling.
2
Pass the supplied screws a and washer b through
each of the power board unit screw holes (A) and
fasten them loosely using washers (4 places).
3
Align the blue sticker (B) on the bracket and the
arrow (B) of the same color on the power board unit,
and then mount the power board unit in the bracket.
● When inserting the power board unit, do it diagonally.
4
Mount the power board unit in the in-ceiling bracket.
Tighten firmly the screws (A) loosely fastened in the
previous step.
2. Installing on the ceiling
5
Attach the supplied safety wire (C) to the ceiling
beam, for example, then connect it to the
bracket-top hole (D).
6
Pass the connection cables through the slit in the
dust sheet (E), and connect the video cable.
7
Insert the bracket into the ceiling hole and fix it
using screws (F) (2 places).
8
Connect the cables and set the switches.
☞ See "Connections and Settings" on page 5.
9
Align the blue sticker (B) on the bracket and the
arrow (B) of the same color on the camera unit, and
then push the camera unit until they click.
À
Align the SANYO logos on the supplied bracket
cover and the bracket, and push the cover until they
click.
■ How to attach the drop-prevention cable
(accessory)
Fasten the drop-prevention cable (G) to the hooks (H) on
the bracket and its cover, then slide the cable as shown in
the figure.
H
G
■ To remove the camera unit
H
1
φ196 mm/7.7"
3
7
6
E
7
Accessories
Dust sheet
Screw a, washer b
(for power board unit)
Safety wire
– 4 –
VA-80MF
2
a
b
A
A
A
B; Blue
C
5
D
D
8 F
7
F
9
B; Blue
Drop-prevention cable
Bracket cover
A
C
5
F