In-Ceiling Mount (Closed Type) - Sanyo VCC-9500 Installation Manual

In-ceiling Mount (Closed Type)

Make sure to also consult the In-ceiling Bracket Closed Type Instruction Manual.
1. Installing the power board unit
1
Draw a circumference on the ceiling using the
supplied drop-prevention cable (A) as compass, and
drill a hole for installing the in-ceiling bracket.
● Pull out the cables from the ceiling.
2
Pass the supplied screws a and washer b through
each of the power board unit screw holes (B) and
fasten them loosely using washers (4 places).
3
Align the arrows (C) of the same color (blue) on the
power board unit and the in-ceiling bracket, and
mount the power board unit. Tighten firmly the
screws (B) loosely fastened in the previous step.
● Pass the video cable (D) through the bracket cable
hole as preparation for the next step.
2. Installing on the ceiling
4
Attach the supplied safety wire (E) to the ceiling
beam, for example, then connect it to the
bracket-top hook (F).
5
Connect the video cable and pass the connection
cables through the bracket.
6
Insert the bracket into the ceiling hole and fix it
using screws (G) (2 places).
7
Connect the cables and set the switches.
☞ See "Connections and Settings" on page 5.
8
Align the arrows (C) of the same color (blue) on the
camera unit and the inner side of the bracket, and
push the camera unit until they click.
9
Align the SANYO logos on the supplied bracket
cover and the bracket, and push the cover until they
click.
■ How to attach the drop-prevention cable
(accessory)
Fasten the drop-prevention cable (A) to the hooks (H) on
the bracket and its cover, then slide the cable as shown in
the figure.
H
A
■ To remove the camera unit
H
Screw a, washer b
(for power board unit)
1
φ192 mm/7.6"
A
3
C; Blue
5
4
6
G
Accessories
Drop-prevention
cable
– 3 –
VA-80ME
B
B
B
E
F
F
G
6
7
G
8
C; Blue
9
Safety wire Bracket cover
2
B
a
b
D
E
4
G