Lexmark J 110 Setup Manual page 19

Step 5:
Attach cables
Attaching a parallel
Clip
Clip
16
Attach cables
You can connect your printer to your computer with
either a:
• Parallel cable
• USB cable
You can connect your printer to the network with an
Ethernet cable (UTP cable with RJ.45 connector).
If you are connecting your printer to a computer with a
cable
parallel cable, use an IEEE 1284-compliant parallel
cable that supports bidirectional communication. We
recommend Lexmark part number 1329605 (10 ft) or
1247498 (20 ft).
1
Make sure the printer and computer (and any
attached peripherals) are turned off and
unplugged from their electrical outlets.
2
Plug one end of the cable into the parallel
connector as shown.
3
Snap down the clips at each end of the
connector.
4
Plug the other end of the parallel cable into the
connector on the back of the computer.
Tighten the cable screws securely.