Phoenix Service Sw; Before Installation - Nokia NSB-9 Service Manual

NSB-9

Phoenix Service SW

Before Installation

• Check that a Dongle is attached to the parallel port of your computer.
• Download the installation package (e.g.
phoenix_service_sw_a3_03_83_005.exe
• Close all other programs
• Run the application file (e.g.
follow instructions on the screen
• Administrator rights may be required to be able to install Phoenix depending
on the Operating System
• If the dongle driver is installed or updated, you need to reboot your PC before
the installation can continue.
• If uninstalling or rebooting is needed at any point, you will be prompted by the
Install Shield program.
If at any point during installation you get this message, Dongle is not found and installa-
tion can´t continue.
Possible reasons may be defective or too old PKD-1Dongle (five digit serial number Don-
gle when used with FPS-8 Prommer) or that the FLS-4S POS Flash Dongle is defective or
power to it is not supplied by external charger.
Check the COM /parallel ports used first! After correcting the problem Installation can be
restarted.
Page 6
Company confidential
phoenix_service_sw_a3_03_83_005.exe
Copyright Nokia. All rights reserved.
CCS Technical Documentation
) to your computer (e.g. C:\TEMP)
) and
Issue 1 04/03