Installing A Firmware Card - Lexmark C 760 Setup Manual

Installing a firmware card

Note:
Firmware and flash memory
cards offered for other Lexmark printers
cannot be used with your printer.
Warning:
Firmware and flash memory
cards are easily damaged by static
electricity. Touch something metal on the
printer before you touch a card.
Follow the instructions in this section to install an optional firmware or flash memory
card.
Only one of each type of card is supported.
1
Remove the system board access cover (see page 20).
2
Unpack the card.
Avoid touching the metal pins on the bottom of the card. Save the packaging.
3
Holding the card by its sides, align the pins on the card with the holes on the
system board.
4
Push the card firmly into place.
The entire length of the connector on the card must touch the system board.
Be careful not to damage the card connectors.
Pins
What do I do now?
Task
Installing a hard disk
Installing an option card
Replacing the system board access cover
Install memory, firmware, or option cards
22
Go to page...
23
24
25